What does CCNA stand for?
A. Cisco Certified Network Administrator
B. Cisco Certified Network Associate
C. Certified Circuitry in Networking Apprentice
D. Calico Cats of North America
- 4 Answers
- 6995 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / m haja bahurudeen
Ans : B
CCNA - Cisco Certified Network Associate
CCNP - Cisco Certified Network Programmer
| Is This Answer Correct ? | 3 Yes | 3 No |
How broadcast is created in switch
What do the following commands accomplish? access-list 1 permit 172.16.0.0 0.0.255.255 interface ethernet 0 IP access-group 1 out interface ethernet 1 IP access-group 1 out A. Only traffic from the source network 172.16.0.0 will be blocked. B. Only traffic from the source network 172.16.0.0 will be forwarded. Non-172.16.0.0 network traffic is blocked. C. Non-172.16.0.0 traffic will be forwarded. D. All traffic will be forwarded.
Which three tasks are required to confound a dial on demand routing (DDR) Basic Rate Interface (BRI) connection? (Choose three) A. define static routes B. confound the abler information C. specify the interesting franc that can enable the link D. define a DDR password to exchange when the link comes up
what are the different symmetric algorithms?
Which ISDN protocol prefix specifies switching and signalling? A.) I B.) E C.) Q D.) S
Which statement should you use to deny FTP access (only) from network 210 93 105 0 to network 223 8 151 0? A. access list 1 deny 210 93 105 0 0 0 0 0 any eq ftp access list 1 permit any B. access list 100 deny tcp 210 93 105 0 0 0 0 255 223 8 151 0 0 0 0 255 eq ftp C. access list 100 deny ip 223 8 151 0 0 0 0 255 any eq ftp access list 100 permit hp any any D. access list 100 deny tcp 210 93 105 0 0 0 0 255 223 8 151 0 0 0 0 255 eq ftp access list 100 permit ip any any
Which protocol is used for booting diskless workstations? A.) IP B.) ARP C.) RARP D.) TCP E.) SNMP
What is the IP extended access list range? A.) 1000-1099 B.) 100-199 C.) 1-99 D.) 101-200
Which of the following is true? A. The default is to send debug output to the console screen. B. To view debug output from a telnet session, the "terminal monitor" command must be used C. If the "logging buffered" command is used, the debug output would be sent to RAM and can be viewed with the "show log" command D. If the "no console loggin" command were configured, output would besent to a telnet session E. All of the above F. None of the above G. A, B, and C. H. A, C, D, and E.
Which protocol you manually enable route summarization?
Can you explain encapsulating, carrier and passenger protocol?
Identify the command to display the IP host table? A.) show ip hostnames B.) show ip names C.) show hosts D.) show ip hosts
CCNA 
