When using TCP, after a session is open, the applications
can adjust the amount of segments they receive before
sending an acknowledgment. This behaviour is known as
______________.
FCS
Windowing
MTU adjustment
Flexible Send Path



When using TCP, after a session is open, the applications can adjust the amount of segments they r..

Answer / jitendera sinha

Windowing

Is This Answer Correct ?    9 Yes 0 No

Post New Answer

More CCNA Interview Questions

Identify 3 characteristics regarding CDP? A.) On by default B.) Shows only directly connected neighbors C.) Requires IP or IPX D.) 60 second update interval by default E.) 30 second updates interval by default

1 Answers  


Which of the following is an example of the Network Layer? A.) TCP B.) IP C.) SQL D.) Token Ring E.) LLC

2 Answers  


Difference between subnetting & Vlan??

7 Answers   Cisco, TCP,


What are the things that can be accessed in a CISCO router’s identifying information?

0 Answers  


What are 10base5 ethernet lans?

0 Answers  


I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used

5 Answers  


How ICMP is used in ping and traceroute facilities

3 Answers  


EIGRP send query reply & Acknowledgment on which address ?

3 Answers  


Routers can learn about destinations through static routes, default, or dynamic routing. By default, a router will use information derived from __________. A. IGRP B. RIP C. IP D. TCP

2 Answers   pspl,


You are logged into a router, what command would show you the IP addresses of routers connected to you? A. show cdp neighbors detail B. show run C. show neighbors D. show cdp

2 Answers  


what is used for passive intercae comand mine answer-to prevent to take update from outside

2 Answers  


Cisco routers can secure the enable password with a one-way hash algorithm. What command would encrypt the enable password with the strong encryption method? A.) enable encrypt john B.) password john C.) enable secret john D.) enable password john E.) secret john F.) enable password 5 john

1 Answers  


Categories