You have typed "ping" 172.16.101.1 and get the following display: Type escape sequence to abort. Sending 5, 100-byte ICMP Echoes to 172.16.101.1, timeout is 2 seconds: .!!!! What does the "." signify? A. That one message timed out. B. That all messages were successful. C. That one message was successful. D. That one message completed in under the allotted timeframe.

1 Answers  

---

Identify the 2 hardware components used to manage and/or configure a router? A.) Auxiliary port B.) ROM port C.) Management port D.) Console port

3 Answers  

---

How many LMI types are available on Cisco routers? A.) Four B.) Two C.) Five D.) Three

1 Answers  

---

Identify 3 characteristics of an IP address? A.) Contains a network portion and a host portion B.) 32 bits long C.) Unique to each network D.) Part of the default Cisco configuration E.) Referred to as the hardware address

1 Answers  

---

Write out a config to permit only the below MAC address to pass traffic through a port on your switch. in another way writhe a confrigation which permit only mac address trfaic through a port of your switch

3 Answers  

---

What does the acronym ARP stand for? A.) Address Resolution Phase B.) ARP Resolution Protocol C.) Address Resolution Protocol D.) Address Recall Protocol

2 Answers  

---

What does the User Datagram Protocol (UDP) provide? A.) Connectionless datagram service. B.) FECN & BECN C.) Flow control and error checking. D.) Name resolution. E.) Path discovery.

1 Answers  

---

Which layer is responsible for negotiating data transfer syntax? A.) Network B.) Session C.) Application D.) Transport E.) Presentation

2 Answers  

---

In port based access-list which command u give instead of ip?

0 Answers  

---

which utility should use to test whether TCP/IP has been initialized on a system.friends plz post the answer with explaination..

3 Answers  

---

What is the second best path name of eigrp?

0 Answers  

---

Identify the 3 methods routers learn paths to destinations? A.) Dynamic routing B.) None of the above, configured by default C.) Default routes D.) Administrative distance E.) Static routes

1 Answers  

---