The command 'debug ip rip' will do which of the following? A.) Show Neighbor Info. B.) Display RIP routing updates. C.) Show routing table changes. D.) Show all IP traffic. E.) This is not a valid router command. F.) Cause the router to respond with 'Ambiguous command'

1 Answers  

---

Which way of communication bus topology use?

0 Answers  

---

Can Anybody tell me if I wanna block all MP3,video sites from cisco 2600 router,how shall i proceed with ACL's?? Please post the steps for the following alonge with detail. Thanks to you all ..appriciated

5 Answers   Cisco,

---

what is the difference between eigrp and ospf

6 Answers   IBM, Wipro,

---

Which network mask should you place on a Class C network to accommodate a user requirement of ten subnetworks? A. 255.255.255.192 B. 255.255.255.224 C. 255.255.255.240 D. 255.255.255.248

7 Answers  

---

Identify the command that saves the configuration stored in RAM to NVRAM? A.) copy running-config startup-config B.) copy tftp running-config C.) copy startup running D.) copy active to backup

2 Answers  

---

Identify the true statements about the following access list: Access-list 101 deny tcp 192.10.172.0 0.0.0.255 any eq 23 Access-list 101 permit ip any any A.) This access list prevents the host 192.10.172.0 from telneting B.) This access list prevents any telnet traffic from subnet 192.10.172.0/24 C.) This access list filters some telnet access D.) This access list denies any telnet traffic to subnet 192.10.172.0/24 E.) This access list is invalid F.) The netmask on the this access list is reversed

1 Answers   HCL,

---

Identify the 3 Internet layer IP protocols? A.) NetBios B.) IPX C.) ARP D.) IP E.) RARP

1 Answers  

---

Name a major component of the Point-to-Point Protocol (PPP) to negotiate and set up control options on the WAN data link. A.) RFC 1661 B.) High Level Datalink Protocol (HDLC) C.) Challenge Handshake Authentication Protocol (CHAP) D.) SS7 E.) Link Control Protocol (LCP)

2 Answers  

---

Switching methods include cut-through, store and forward, and a modified version of the first two methods. Which statement about switching methods is true? A. The store and forward method has low latency B. The cut through method of switching has high latency C. The modified version holds the packet in memory until 50 percent of the packet reaches the switch D. The modified version holds the packet in memory until the data spoon of the packet reaches the switch

3 Answers  

---

Mention what is the difference between dynamic ip and static ip addressing?

0 Answers  

---

Which Circuit is mostly used by Clients in Frame-Relay PVC or SVC ?

5 Answers   TATA,

---