Answer / guest

Answer: B D

'Boot system' command the 'config-register' are used to
manipulate the

boot sequence.

Given the configuration example<HR> <B>interface ethernet0 ipx network 4a ipx access group 800 out interface ethernet1 ipx network 3d interface ethernet2 ipx network 5c access list 800 permit 3d 4a</B><HR> Which two actions result from implementing this configuration? (Choose two) A. IPX network 5c will not receive any traffic B. Traffic from network 3d for network 4a will be forwarded out e0 C. Traffic from network 4a for network 3d will be forwarded out e0 D. Traffic from network 3d destined for network 4a will be forwarded out e2 E. The access list is applied to an outgoing interface and filters outbound traffic

1 Answers  

---

Explain the draw back of ospf protocol?

0 Answers  

---

What are four functions/characteristics of the network layer of the OSI model? (Choose four) A. It uses a two-part address B. It maintains routing tables C. It uses broadcast addresses D. It establishes network addresses E. It provides access to the LAN media F. It provides media independence for upper layers G. It provides path selection for Internetwork communication

1 Answers  

---

What is the result of segmenting a network with a router into segments 1 and 2? A. It increases the number of collisions B. It decreases the number of broadcast domains C. It connects segment 1 and broadcasts to segment 2 D. It connects segment 1 and broadcasts from genre to segment 2

2 Answers  

---

What are four ways that Fast Ethernet compares to 10BaseT Ethernet? (Choose four) A. Fast Ethernet uses the same Maximum Transmission Unit (MTU) B. Fast Ethernet is based on an extension to the IEEE 802.3 specification C. Fast Ethernet uses the same Media Access Control (MAC) mechanisms D. Fast Ethernet preserves the frame format that is used by 10BaseT Ethernet E. Fast Ethernet errors a speed increase one hundred times that of the 10BaseT Ethernet

1 Answers  

---

In Novell's use of RIP, there are two metrics used to make routing decisions. Select the two metrics. A. Ticks. B. Hops C. Loops D. Counts

3 Answers  

---

What is an administrative distance of 0 mean? A.) 0 means unbelievable B.) 0 is for EIGRP C.) 0 is the default distance for directly connected networks D.) 0 means unreachable

2 Answers  

---

which device/card is used at the end of computer/device to connect multiple or different wire of mesh topology to a single computer/device?

1 Answers   Adepto, British College, Wipro,

---

Hi all of you, Actually this is interview qe? but i did,t do explain it completely so please give reply recently and completly Ans, what is sub-interface and inter-vlan ? And How to implement it on cisco router & switches and also which series router switches supported please write..........

2 Answers   Cisco,

---

Select the correct statements about PPP and SLIP for WAN communications? A. PPP uses its Network Control Programs (NCPs) component to encapsulate multiple protocols. B. PPP can only transport TCP/IP C. SLIP can only transport TCP/IP. D. SLIP uses its Network Control Programs (NCPs) component to encapsulate multiple protocols.

1 Answers  

---

Which encapsulation methods are most commonly used with dialup Integrated Services Digital Network (ISDN)? A. IP and IPX B. IP and PPP C. PPP and SDLC D. PPP and HDLC

2 Answers  

---

Identify 3 characteristics of ISDN? A.) Transports voice and data B.) Transports voice only C.) Support both BRI and PRI D.) Runs over existing phone lines E.) Same as X.25

1 Answers  

---