what is burst rate

1 Answers   ASD Lab,

---

How does a web page works though each layers ?

5 Answers   HCL, PBPL,

---

What is true when using DDR? A.) HDLC is the preferred encapsulation B.) You must use static routing C.) You should use dynamic routing D.) You should use ISDN

1 Answers  

---

here is your question sahin Hi Jitendera, If i m not wrong, then in EIGRP, Metric weight is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1, K4(Load)=0, K5(MTU)=0. This is default setting for EIGRP. I knew about it from ICND 2 cisco press book. Three more questions - a) If we change the K value (I mean metric weight)on a router what will happen??? b) When redistribution is necessary in EIGRP. Is there any condition for that??? c) What is reference bandwidth for metric calculation in EIGRP. As we know, in OSPF, on a CISCO router reference bandwidth is 10Mbps.

3 Answers  

---

Which statement about Ethernet switches is true? A. Symmetric switching allows connection between pods of unlike bandwidth and does not require memory buffering B. Memory Buffering is used to prevent a bottleneck when pods of different bandwidth are connected on a symmetric switch C. The latency can be reduced if the switch utilizes the store and forward method of switching store and forward is better for error detection D. The cut through method of switching is faster because the switch forwards the packet to the destination as soon as it reads the destination address

1 Answers  

---

What are the difference between IPv4 & IPv6?? Can anyone explain more details about it..!!

9 Answers   HCL,

---

Identify 3 features of IGRP? A.) Composite metric B.) New horizon C.) Flash updates D.) 60 periodic updates E.) Poison reverse

1 Answers  

---

Given the command 'cl?', what will it display? A.) Syntax of the 'clock' command B.) Syntax of the 'clear' command C.) All commands that begin with 'cl' D.) All commands that begin with 'c'

3 Answers  

---

Which IP Address Class is INCORRECTLY paired with its range of network numbers? A. Class A addresses include 192.0.0.0 through 223.255.255.0 B. Class A addresses include 1.0.0.0 through 126.0.0.0 C. Class B addresses include 128.0.0.0 through 191.255.0.0 D. Class C addresses include 192.0.0.0 through 223.255.255.0 E. Class D addresses include 224.0.0.0 through 239.255.255.0

4 Answers  

---

Explain the benefits of vlan?

0 Answers  

---

What is DLCI?

0 Answers  

---

When you enter router passwords during the setup dialog what is the difference between enable and the enable secret passwords? A. The enable password is encrypted B. The enable secret password uses IPSec password authentication C. The enable secret password cannot be seen as clear text when viewing the configuration D. The enable secret password acts as a backup in case the enable password is compromised

8 Answers   Wipro,

---