Interested to Buy Any Domain ? << Click Here >> for more details...
Given an IPX network with redundant paths, what command will
configure load balancing?
A.) ipx load-balance
B.) ip maximum-paths 2
C.) ipx maximum-paths 2
D.) ipx load-share
- 1 Answers
- 4201 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: C
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
Tell me how many fillers we can put in one ip of ipv6?
Which protocol supenetting is enable by default?
What is passive topology in ccna?
How many types of router?
Suppose a Switch interface went in error-dis mode what you will do for Troubleshooting List all Possibilities
When we use interface mode?
What is the command use to add a banner to a cisco router configuration?
What is default cost of serial interface in ospf?
What are the different types of VPN?
Define the virtual channel?
What are the possible ways of data exchange in ccna?
On which mode we give debug command?
What is the difference between dynamic ip and static ip addressing?
What is difference between rip and ripv2?
