Answer / k.prakashchandra

SFU =Incomer> switch >fuse> load unit, FSU =Incomer> fuse>
switch > load unit.Actually FSU is better as it protects
against fault in switch also.SFU is preferred if bare open
fuse wires are used, as fuses can be replaced without
opening at the origin.FSU is preferred when Cartridge type (
HRC)fuses are used.

WHAT HAPPENED HT MOTOR FEED WITH LT SUPPLY

1 Answers  

---

What meant by lagging and leading? When if they are occurred what preventive methods should be taken?

14 Answers   ABB, L&T,

---

if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current

0 Answers  

---

can u describe the method used for protection of transmission line.

0 Answers   IBM,

---

what is ten delta ?

2 Answers   ABB, Areva,

---

why we are using large cross section cable at load side and small at other (11kv to trsfr)side of transformer? when the load increses current at both side increases,right?

2 Answers  

---

What is the use of insulation tester and how it is to be used.

2 Answers  

---

Can we use 11kv Trivector Metre or Energy metre instead 33kv Metre at 33kv Over Head Line metering purpose?

5 Answers   Bhel,

---

Why generation voltage in thermal power plant is between 11kv to 33kv?

0 Answers  

---

Does magnetomonopoles exists? one maxwell equation strongly suggests no, but how about their existance in plasma?

0 Answers  

---

What is meant by a stray loss of a induction motor??? What is the equation to find it

0 Answers  

---

what is the thumb rule or formula for cable size and current ratings

1 Answers  

---