A user device that connects to a DCE must be which of the following? A.) DTE

A user device that connects to a DCE must be which of the
following?

A.) DTE

B.) CPE

C.) Demarc

D.) DCE

E.) CO

Question Posted / guest

1 Answers
3646 Views
I also Faced
E-Mail Answers

A user device that connects to a DCE must be which of the following? A.) DTE B.) CPE C.) D..

Answer / guest

Answer: A

DTE's are the router side, and receive clocking.

DCE's are the DSU/CSU side, and provide clocking.

It may or may not be Customer Premises equipment.

Is This Answer Correct ?

3 Yes

0 No

Post New Answer

More CCNA Interview Questions

which utility should use to test whether TCP/IP has been initialized on a system.friends plz post the answer with explaination..

3 Answers

Difference between Distance vector, Link state protocols

3 Answers HCL,

Given the following output, how can we close Telnet session 2? (Choose two) CCNA2620#show sessions Conn Host Address Idle Conn Name 1 131.108.100.152 131.108.100.152 0 131.108.100.152 *2 126.102.57.63 126.102.57.63 0 126.102.57.63 ❍ A. Press the Enter key and enter exit. ❍ B. Enter disconnect 2. ❍ C. Press the Enter key and enter disconnect 2. ❍ D. Enter close 2.

1 Answers

What are the two most common request/reply pair with ICMP messages when using the ping command? (Choose two) A. echo reply B. echo request C. source quench D. fragment onset E. information redirect F. destination reachable G. echo control message

1 Answers

Which of the following do not belong to the customer? A.) CO B.) DCE C.) Router D.) CPE E.) Demarc F.) DTE

1 Answers

what are loops in switches excactly...and how does it gets created???

1 Answers

How many types of memories are used in cisco router?

0 Answers

What is the IEEE specification for Spanning Tree Protocol? A.) 802.9 B.) 803.ud C.) 803 D.) 802.1d

1 Answers

IGRP supports a feature that allows traffic to be distributed among up to 6 (4 default) paths to provide greater overall throughput and reliability. What is this called? A. unequal-cost load balancing B. equal-cost load balancing C. proportionate load balancing D. low cost load balancing

1 Answers

What does a Standard IP Access-list use as test criteria? A.) IP source address B.) IP source and destination address, protocol numbers and port numbers C.) IPX source and destination address D.) Source MAC address

2 Answers

Operation of two PC connecting with brand new switches. (they expecting step by step arp ,broadcast,MAC table, RARP operation)

2 Answers HCL,

what's the difference between Symmetric and Asymmetric cryptosystem?

0 Answers CCIE,

For more CCNA Interview Questions Click Here