hi... i am usin packet tracer 5.0.. i hav connect two routers A and B. A has 200.100.25.100 and 1.0.0.1 and router B has 200.100.50.100 and 1.0.0.2... i hav connected 1.0.0.1 and 1.0.0.2... now i want to route 200.100.25.100 and 200.10.50.100 usin rip.. i enable rip in both the routers... but whn i give the command show ip route... i jus get this Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set A# so can sombody tell me where i hav gone wrong... thanku

1 Answers  

---

What is a key use of a device hardware address? A. to obtain a vendor code / serial number from the user B. to transmit a frame from one Interface to another Interface C. to transmit a packet from one local device to another local device D. to transmit data from one local device to a remote device across the internet E. to contain logical information about the device to use for end-to-end transmission

1 Answers  

---

When setting up a WAN network, everything outside of the Demarc is not owned by the customer. Which of the following are not owned by the customer? A.) The T1 line. B.) LAN C.) The Router D.) DTE E.) PC's F.) CO

1 Answers  

---

What is the default CDP broadcast update rate for Cisco routers? A.) 120 seconds B.) 60 seconds C.) 30 seconds D.) 90 seconds

1 Answers  

---

Given the IPX address 4a.0002.1111.a999, what is the network ID and what is the node ID? A.) net 4a host 0002.1111.a999 B.) net a999 node 0002.1111 C.) net 0002.1111.a999 node 4a D.) net 0002.1111 node a999

2 Answers  

---

hi jitendra i am sunil here and i am an engineering student from delhi i have lots of interest in computer network.i was in serch of doing communication through MAC adressess.can u help me?

1 Answers  

---

What 2 commands verify end to end communications? A.) Trace B.) debug ip session C.) Ping D.) Route

2 Answers  

---

Which three basic switch functions increase available bandwidth on the networks? (Choose three) A. loop avoidance B. address learning C. hop count limiting D. broadcast filtering E. packet forward/filtering F. broadcast packet hop count learning/forward/filtering

1 Answers  

---

Why ip address called logical address?

0 Answers  

---

What is the purpose of the DLCI? A.) Identifies the remote routers B.) Contained with a 802.2 frame for routing purposes C.) Used with PPP during authentication D.) Identifies the PVC in a Frame Relay network

1 Answers  

---

What is icmp protocol?

0 Answers  

---

Which of the following are ways to provide login access to a router? A.) HTTP B.) Console C.) Telnet D.) Aux Port E.) SNMP F.) LLC

3 Answers  

---