When determining whether or not to route a LAN segment, which rule of thumb

When determining whether or not to route a LAN segment,
which rule of

thumb do you use?

A.) 60/40

B.) 50/50

C.) 80/20

D.) 90/10

E.) 70/30

Question Posted / guest

2 Answers
5479 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

When determining whether or not to route a LAN segment, which rule of thumb do you use? A.) 6..

Answer / guest

Answer: E

Is This Answer Correct ?

3 Yes

0 No

When determining whether or not to route a LAN segment, which rule of thumb do you use? A.) 6..

Answer / rick

can u expain this thumb rule ?

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More CCNA Interview Questions

Which element is used to define the rate in bits per second that a Frame Relay switch agrees to transfer data? A. clock rate (CP) B. Committed Information Rate (CIR) C. Local Management Interface (LMI) D. data link connection identifier (DICI) E. Committed Rate Measurement Intercal (CRIMI)

2 Answers

Identify the following components of the IPX address 2e.0000.0065.ed43 A.) Not a valid IPX address B.) Network = 2e, Subnet = 0000, Node = 0065.ed43 C.) Network = 2e.0000, Node = 0065.ed43 D.) Network = 2e, Node = 0000.0065.ed43

1 Answers

The ICMP (referred to in PFC 1700) is implemented by all TCP/IP hosts A. true B. false

1 Answers

A ISDN PRI circuit can be described as which of the following? A.) 24 B channels and 1-64Kbps D channel B.) 23 B channels and 1-64Kbps D channel C.) 2-D channels and 1-C channel D.) 2-64Kbps B channels and 1-16Kbps D channel

1 Answers

What are the OSPF router rules????

6 Answers NIIT,

Which of the following protocols are used to get an IP address from a known MAC address? A.) BootP B.) TCP C.) IP D.) ARP E.) RARP F.) ICMP

1 Answers CMC,

Identify the named IP access-list number range? A.) 600 - 699 B.) 1 - 99 C.) 900 - 999 D.) 200 - 299 E.) none of the above

2 Answers

How many reserve ports?

0 Answers

Identify the components in the following command 'interface serial0/1/1' A.) Serial interface, port number 0, slot 1, port adapter 1 B.) Serial interface, slot 1, port number 1, port adapter 0 C.) Serial interface, slot 0, port adapter 1, port number 1

1 Answers

Station A is transmitting data to station B faster that station B can handle it. When station B's buffer fills up, it send out a message to station A to stop sending data. After B empties out its buffer, station B sends a message to station A to start sending data again. This is most directly an example of (pick the best answer only): A.) Poison Reverse B.) Connectionless protocol C.) Windowing D.) Connection oriented protocol E.) Flow Control F.) Split Horizon

1 Answers

Which command would you type to show SAP and RIP updates you are receiving on an interface? A.) sh ipx servers B.) sh ipx traffic C.) sh ipx interface D.) sh ipx route

2 Answers

What are the two most common transport layer protocols? UDP TCP IPX ARP

3 Answers

For more CCNA Interview Questions Click Here