Bus-bar is made of which material & name of mostly used
material in bas-bar design ?
Answers were Sorted based on User's Feedback
Answer / md imran
Bus-bar is made up of aluminium.
there are bus-bar is made of aluminium,copper.
| Is This Answer Correct ? | 37 Yes | 4 No |
Answer / mita mhamal
BUS BARS ARE OF 3 TYPES
1-ALLUMINIUM BUSAR,
2-COPPER BUSBAR
3-ALLUMINIUM COATED COPPER BUSBAR OR TINNED BUSBAR...
IT DEPENDS ON THE LOAD WHICH BUSBAR TO USE..
BUT MOSTLY WE USE COPPER BUSBARS....
| Is This Answer Correct ? | 26 Yes | 4 No |
Answer / p.phalgunarao
busbar is made of aluminium condutor.
this is mostly used in sub-stations
bus bar is 3 typs
1.al
2.cu
3tinned
| Is This Answer Correct ? | 17 Yes | 3 No |
Answer / sennapparajan
copper is the dedicated material for busbars. for reducing
cost people using aluminium also.aluminium having low KA
rating capacity.
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / s.venkatraman
Alu r copper. most company used to alu only
in case load is high increase bus nos r size
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / abhishek saxena
bus bar are made with aluminium cored steel reinforced metal
(ACSR).
this is cheeper than copper,and generally used.
| Is This Answer Correct ? | 1 Yes | 5 No |
can anyone show me how the 3 phase power is supplied to socket outlets?
what are the materials used in HRC fuse
how we arrange the hv side with delta connection in case 33/11kv of transformer.
what is automatic voltage regulator and it is used?
What is the difference between LT & HT Cable
how we calculate size of exciter(excit. volt and current) for generator?
How does a system control centre in a utility plant gets the grid frequency of the electrical network (50 Hz or 60 Hz)by the SCADA system?
is it possible to flow currnet between earth and nutral wire in a circuit???
how to calculate multiplying factor with ct ratio 400/5
explain the operating principles of CVT & RVT
Give accurate definitions for these electric terms: Inductor Inductance Inductive Induction Reactance Reactive Esam Baraka ٢١ ساعة
how terminal voltage increases when load is capacitive (leading pf load)? (explain practically what is happening, not using phasor diagram
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)