How can remove the jerks on genretor due to remov or
connecting the load ?
- 3 Answers
- 4337 Views
- I also Faced
- E-Mail Answers
Answer Posted / shekar
By mounting a fly wheel to the shaft of generator
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
what happen if the supply is given to the stator of the 3phase induction motor with out assembling the rotor ?
how we find transformer capacity by ohm
what is cause of static electricity? I experience shock when i touch metal equipment in a room ,furher check shows earth leakage showing 80ma at the DB near to the 400 MCCB?
Logic using 1 kV or 1,1 kV grade in house wiring Low voltage cable. Explain/suggest? some use 1kV and some prefer 1.1kV grade insulation low voltage cable why??
what is zinc diffusion?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
for hipot test on 33kV busbar, we will test on 70 kV or 56kV, what is the acceptable leackage current?
how to calculate units consumption for a 12 hp motor /hr.
can we install HT panel & LT panel side by side or how much clearance is required ?
I COMPLITED MY B.TECH AND 10TH CLASS WITH 70%MARKS BUT 12TH CLASS 55%MARKS..CAN I GET INDIAN RAILWAY RECUREMENT EXAMINATION?
Why we are use dol starter up to 10 hp
what is the difference between fault current ant short circuit current?
How maesure earth neutral value & how much maximum value value required in between earth & neutral.
WHAT IS THE FORMULA FOR CALCULATING CURRENT RATING(DIRECT IN GROUND OR AIR) OF ARMOURED(XLPE) CABLE OF 4C,16Sqmm?
I need the list of Universities who have summer intake for BS degree in Electrical Engineering.?
