How can remove the jerks on genretor due to remov or
connecting the load ?
- 3 Answers
- 4339 Views
- I also Faced
- E-Mail Answers
Answer Posted / basheer ahmed
BY CONNECTING A STARTER i.e. A LARGE RESISTANCE IN SERIES
WITH THE GENERATOR AND IS ADDED IN STEPS.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
how to flameproof electrical motor on the shaft?
Difference between on line capacitor and Station type capacitor
wow to calculate the transformer rating(KVA)
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
What is 100% protection of generator? Why 100% is not used but 95% is generally used?
what kind of technical test that i need to learn because i have an interview tomorrow.. please someone help me..
HOW THE OLTC TRANSFORMER SAVE ENERGY IN COMPARISON TO OFF LINE TRANSFORMER AND IS IT ECONOMICAL TO REPLACE THE OFF LINE TRANSFORMER TO OLTC TRANSFORMER
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
what is the difference between fault current ant short circuit current?
design of IGBT firing circuit for 11KV
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
If we have 11 kv RYB Phase single core cable near about. Then wht effect and losses
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
how can i determine the KVA/MVA rating of transformer precisely?? is there any standard test?????
how to test reverse power trip?
