Answer / vaibhav

yes we can drive the 50Hz motor on 100Hz by using variable frequency . and as we know that synchronous speed =120*f/p.
as frequency increase motor speed also increase. and also if frequency increase motor size also can be decrease in design if want to decrease

Answer / zenat

it will effect the motor speed,everything will run
(100-50)*100/50=100% faster than normal speed...which may
damage the motor.

Answer / clinton

If you are using a inverter on a 50Hz motor.
At 50Hz the VSD is usually outputing 400V
If the motor is connected in star the volage across each
coil is 230V at 50Hz. The motor will run with designed
magnetising current therefore can produce the correct
torque, then the load is increase. If we continue in
frequence, the magnetising current is lower, and therefore
the motor will loose torque.
Connect the motor in delta and change the settings to 415V
at 100Hz and the same magnetising curve is produced.
Therefore the motor will not stall due to lower torque
charactistics.

why we use to transmit the power in three phases intead of single phase ?

4 Answers  

---

what is the frequency of direct current(dc)?

12 Answers   Cognizant, University,

---

in transmission line, if the load is suddenly increased at the receiving end of the system the phase shift will (a)decrease (b)becomems zero (c)increase (d)not be affected

4 Answers   Getco,

---

how a vibration switch's high signal will going to trip the motor? can u explain with some examplesand wiring diagrams?

1 Answers   Bhel, Wartsila,

---

Anyone who can recommend an equivalent to Envirotemp FR3 of Cooper?

0 Answers  

---

why for transformer protection we protect tranformer from 3rd hormonics and 5th hormonics and what is the reason of generating these horminics in electrical system?

2 Answers   Essar, LG, OPS,

---

2. What are the parameters of EHT sub-station?

1 Answers   APGenco, Blue Star, Enercon,

---

E.B sending end to receiving end 33kv ug cable laid 8Km,receiving end to ss1,ss2,ss3,ss4 all are Approx 800 Mtr,can go for 33KV to 430V or 33kv to 11kv in receiving end and 11kv to 430 near ss ,which one is good for technically and economically.

1 Answers   JLL,

---

What is gross error?

0 Answers  

---

Whta is WT in a transformer, specify its function.

4 Answers  

---

IF TVM OF TRANSFORMER SHOWS POWER FACTOR ON 33 KV SIDE AS 0.97 LAGGING AND ON 132 KV SIDE IS 0.75 LEADING.IS THIS CORRECT.WHERE IS PROBLEM.

0 Answers  

---

how does commutator convert a.c to d.c?

0 Answers   NRSC National Remote Sensing Centre, RBC,

---