what is the diffrence between R Y B phase and why it is
called RYB
Answers were Sorted based on User's Feedback
Answer / asmita
Voltages of these 3 phases r 120 degrees apart from each
other.i.e there is 120* phase diffrence.they r might given
names from three basic colours Red,yellow & Blue.
Is This Answer Correct ? | 34 Yes | 8 No |
Answer / avtar singh
above answer is right but we always see the phaser diagram
of the 3 phases in clockwise direction so we say RYB
Is This Answer Correct ? | 10 Yes | 7 No |
Answer / 7anoter4
The phases graphic representation R Y B actually it rotates
clockwise: fisrt is R(Red), second Y[Yellow] -after 120 dgr
=1/3 full wave=1/60/3 sec,and third will be B[Blue] after
another 120 dgr.
Sorry! My mistake. I forgot how the analogic clock hands are
moving. The phases are moving on the trigonometric circle-as
the angle increases- that means anti-clockwise[from right to
left].
Is This Answer Correct ? | 3 Yes | 1 No |
Answer / raj
the fact is that phasors rotate in anti clockwise direction but they are named in clockwise direction...try thinkin over it for a moment, it will make sense..
Is This Answer Correct ? | 3 Yes | 2 No |
Answer / asmita
MMr.Singh we alwys consider that phasors always rotate in
anticlockwise direction n not clockwise
Is This Answer Correct ? | 5 Yes | 8 No |
What happen if you keep open the Neutral Grounding Switch in open condition of the HT Generator at starting and again on load if it open then?
What is boucholz relay and the significance of it in to the trformer?
why should we connect the no load components in a equivalent circuit of transformer in parallel?why cant it be in series.
Electromagnetic torque developed by the motor is compared to shaft torque. A less B same C depends on motor design D more
which bulb is greater iluminited, 60w and 100w are conected in series?
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
How to select Main CB Rating for 220 KW Load?
our company have 750 kva oil transformer.still we have facing a problem that is when voltage is 11.5 kv coming from HT side then LT-side voltage is 420v or above at tape 1.please give me best solution to decrease the voltage.
how many wires need to be bring to the motor if its star delta starter
What are the applications of different multistage amplifiers?Plz also write advantages of these amplifiers? Thaaaaaaaaanx
what is IP55,IP65
Resistor switching is used in which type Circuit Breaker ? a) oil filled CB b) Air blast CB c) Gas filled CB
11 Answers Engineers India Limited, wbsedcl,