Interested to Buy Any Domain ? << Click Here >> for more details...
what is the diffrence between R Y B phase and why it is
called RYB
- 5 Answers
- 24366 Views
- I also Faced
- E-Mail Answers
Answer Posted / 7anoter4
The phases graphic representation R Y B actually it rotates
clockwise: fisrt is R(Red), second Y[Yellow] -after 120 dgr
=1/3 full wave=1/60/3 sec,and third will be B[Blue] after
another 120 dgr.
Sorry! My mistake. I forgot how the analogic clock hands are
moving. The phases are moving on the trigonometric circle-as
the angle increases- that means anti-clockwise[from right to
left].
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
why the electrolyte level in lead acid battery is maintained 2.5 cms above electrodes?
orifice sizing how done, checking & selection
State kirchoff current law?
why all the feeders are designed in a particular manner ... is there any reason for that???
how to calculate regulation constants for over head lines? and what are the regulation constant for raccoon conductor at different voltage level and different P.F?
What is the operating principle of turbo-generator.
Hi all I had applied for the RRB test in the ELECRICAL category. I would be pleased if any of you can sent me previous year question papers. Please forward the question papers to varshashahi@yahoo.com Thanks and regards Varsha
What is the physical significant of power factor?
what are the effects when a salient pole alternator is run at high speed like 3000 r.p.m?
How to set the relay,,??
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
Where burned of electricity,when,who, & why.
At what factor resistance r of a conductor depends?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
