Answer / parth belani

if you are talking about measuring the resistances
practically, then you just have to set the multimeter on
OHM measurement and put it across A AA terminals (for
armature resistance) and F FF terminals (for field
resistance).

A ray hit a smooth regular surface at an angle of 20 from the normal. Calculate : 1. The angle btw the incident and reflection ray. 2. The angle of deviation.

0 Answers  

---

if 12v battery get discharged for 2 months after if we put charge it will charge again?how much time it will take to charge?

0 Answers  

---

Do u know any one? how to find out in motor rated amps? formula?

0 Answers   Banking, ET,

---

If in a 3 phase supply if the load current is 200A what value of current the each phase R,Y & B will carry?

5 Answers  

---

how we sesign the transformer give some specifion regarding design of transformers

0 Answers  

---

11kV capacitor bank of rating 2.4KVAR, is charged with protective relays of only over current & Earth fault &.......without Over Voltage, Under Voltage & Neutral Displacement Relay. Is it advisable??

0 Answers  

---

Is only insulation the difference between High voltage and Medium voltage cable?

1 Answers  

---

why do we use spark detector inside the slip ring brush compartment 0ona slip ring induction motor?

0 Answers  

---

single phase can run in PVC conduit. Three phase can also run in one PVC conduit. But two phase cannot run in one PVC conduit. WHY? reply plz....awaiting your answer.

8 Answers   L&T,

---

state the disadvantages of carbon filament???

0 Answers  

---

What is mean by sinewave.

0 Answers  

---

why single core HT cable need only one side earthing?

2 Answers  

---