In waterfall model, while your are coding if you happen to know that one of th

In waterfall model, while your are coding if you happen to
know that one of the requirement was wrong and there will
be no use in implementing it and moreover it is going to
cause problems to the final output. Then do you have the
flexibility to go back and change the requirement?

Is this flexibility there in Vmodel?

Question Posted / swathisamyuktha

3 Answers
4585 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

In waterfall model, while your are coding if you happen to know that one of the requirement was wr..

Answer / amrita

No in waterfall model its not posible to go back to previous
stage.............if we found any bug or error..............
yes in V Model its possible..................

Is This Answer Correct ?

6 Yes

1 No

In waterfall model, while your are coding if you happen to know that one of the requirement was wr..

Answer / tushar nagarkar

No the basis of waterfall model is to go through all the
steps of SDLC but does not allow to go a phase back....
However real time scenarios may differ but for the
question's sake lets take the answer as NO

Is This Answer Correct ?

5 Yes

1 No

In waterfall model, while your are coding if you happen to know that one of the requirement was wr..

Answer / qaprofessional

I think its not possible, as both these are sequential
models! As stated you have started coding, so the design are
completed and the test cases have all been prepared.

Is This Answer Correct ?

0 Yes

1 No

Post New Answer