Answer / sindhejs

To find the resistance of the conducting device, apply the
ohms law to it. That is connect the voltage source to it,
apply the voltage and note down the current and volotage.
By using the formula V=I*R, calculate the Resistance R.

Answer / hitendra

By colour coading system we find out resistance but, it
must be standard.

Answer / manda

hi frinds,
it is applicable in resistive device and dc system,

what is the relation bw voltage and F in capacitor?

3 Answers   TATA, Tata Motors,

---

what is ceiling voltage in an exciter?

1 Answers   KEPCO Energy Service Company,

---

Is a induction motor rotate by back emf ? If not , then how it is rotate ?

1 Answers  

---

funtion of choke

4 Answers   L&T,

---

How to find earthfault location in long cable layed underground or outside.

3 Answers  

---

what is meant by skew width in machines?

0 Answers  

---

In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.

0 Answers   PPIL,

---

what will happened to give the dc supply to ac transformer?

3 Answers   Sail,

---

ho w to make Incident and accident reporting

1 Answers  

---

I hv a question regarding power factor improvement just after transformer. I request you to reply me plzz. thank you sir. My friend has a small unit of fabrication. in his factory the main load is a welding machine, lathe machine, grinding machine. this load is not continuous type. now our electricity board has installed 16 KVA, 11000/433 V transformer for our factory. In the energy meter (trivector meter) at LV side of transformer, i hv seen power factor value of 0.15 only when only 3 KW load was flowing. Further electricity board has suggested to install 4 KVAR capacitor at LV side after energy meter. Now my question is that if we permanantly install and switch on 4 KVAR capacitor after energy meter, during some load on transformer and also without any load on transformer, wht will be the power factor shown in energy meter?i dont want to get any penalty by electricity board, so plz suggest me if i can permanantly install and switch on the 4 kvar capacitor or not at LV side of transformer just after energy meter? Thank you again and awaiting for ur positive reply soon.

9 Answers  

---

why in scott connection of transformers, main transformer is tapped at 50% and teaser transformer at 86.6%?

5 Answers   Bhel, Bosch, College School Exams Tests, Wipro,

---

why capacitor rating measure in KVAR. ?

2 Answers  

---