Answer / umair iqbal

An electrical grid is an interconnected network for
delivering electricity from suppliers to consumers.

Answer / lokesh

Of Course Grid is Interconnected system of more than one
no.of distribution stations connected together for the
pupose of load balancing. In some case the distribution
transformers have distribute peak supply sometime. Also
there will be low consumption power distribution
occurs.during this period load balancing can be done
through this grid.apart from this as we are paralleling
more than distribution system, in case of any break down in
any one of the distribution system, then that transmission
line can be feeded through some other distribution
transformer by tapping with load changer.

Answer / yatish

In short grid is a space provide transmission and
distribution of electrical energy .

Answer / r. thirumoorthy

IT IS THE INTERCONNECTION OF TWO OR MORE DISTRIBUTION
NETWORKS. IF ANY ONE OF THE DISTRIBUTION SYSTEM AFFECTED BY
PEAK LOAD OR MAINTENANCE PROBLEM,THAT CONSUMERS ARE GET
POWER SUPPLY FROM OTHER DISTRIBUTION SYSTEM OF THE GRID.
LOAD BALANCING IS THE MAIN AIM OF GRID SYSTEM.

Answer / s,vivekanandan

Grid is the interconnected network of differnt Generating
Stations and Sub-Stations at various voltage levels for
distributing and consuming the generated electrical Power.

Answer / vilas chavan

A network of cables/ transmission lines for distributing
power especially high voltage electricity.

Answer / vilas

Grid is a transmission lines Network.
through which power / voltage is supplied to the h.t. and
l.t. consumers.

Why an ac solenoid valve attract the plunger even though we interchanges the terminal? Will the poles changes?

0 Answers  

hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"

0 Answers  

List the characteristics of filter?

0 Answers  

Describe the test procedure to determine the vector group

0 Answers   MPSEB,

What is the range of the stator resistance of 3 phase induction motor?

1 Answers  

3.The slip of an IM UNDER FL condition is about.....

1 Answers   SSC,

how to calculate singlephase motor efficiency?

0 Answers   Alstom,

When batteries are connected in series the voltage increases but the current remains unchanged, how can this be? When you consider ohm's law. i.e. If voltage increases, current increases, providing resistance remains the same.

10 Answers  

what is the purpose of slope in the differential relay?why we are using two slope?but in busbar differential we are using only one slope.why?

0 Answers  

in our sub station why we step down firstly 33kv\11kv then 11kv to 430v. can we direct step down 33v to 430.v.

18 Answers   Eaton, Siemens,

Explain difference between stand by earth fault and residual earth fault protection?

0 Answers  

Three phase power is measured with two wattmeeter for balance three phase load.the reading of one wattmeter is zero.we can conclude that the power factor of balance load is?

1 Answers