Interested to Buy Any Domain ? << Click Here >> for more details...
It is observed that AVR of an Alternator is more likely to
fail if the Generator and Mains Neutral are directly
connected to each other. Why should this be so?
- 1 Answers
- 3808 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
The voltage in neutral of gen during earth fault will be fed
to the neutral of AVR which may get damaged , being an
electronic equipment
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What do you mean by screen of power cables?
1. for eg, capacitor is used for many purposes(it act as filter, oscillator, bypass capacitor, memory storage etc...) 2. Please tell me some example circuits for different uses of capacitor( whenever and whereever and however we used capacitor as a filter, oscillator tuning etc..) 3. similarly for inductor and resistors(it act as what?) and when and how we want to act as like that?, and how we can used these components depends upon our requirments with example circuits and explanation? design to act as these components depends
What are the advantages and disadvantages of closed-loop control system?
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
Why are the laminations insulated from each other?
What is the loss of power of transformer 220kv/33kv,63/80mva of % imp12.05 at 80%load
Some times to change of DOR of a motor, interchange of R & B is not effected and RYB take same current, but interchange of R&Y is effected ie change the DOR. My doubt is what is the problem in motor and how it is happen.
what is the string efficiency
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
Why is the air gap between the pole pieces and the armature kept very small?
what is a composite error in current transformers, why occurs & in which it will occur i.e, either metering ct/ protection ct
how to find Harmonics and types as per the equipemnts
What is meant by reverse polarity and how it can be fixed?
If Dg set load increase 25%, How much increase fuel Consumption (15 kva 2 cylinder DG set)
