WORKING PRINCIPAL OF MCB
Answers were Sorted based on User's Feedback
Answer / puneet kumar
whenever a input current flows above the certain specified
value then MCB interrupt the phase i.e. break the circuit.
This certain value is define by rating of MCB connected on
a particular ciruit(for light circuit or power circuit).
Is This Answer Correct ? | 34 Yes | 8 No |
Answer / shenba
MCB- miniature circuit breaker,
it breaks the circuit when there is over current flows on
the line which exceeds the crt ratting of mcb used.
ITs also due to when load connected having any short
circuit bpms then mcb trips or breaks the ckt.
Is This Answer Correct ? | 7 Yes | 0 No |
Answer / jeet c. ganatra
whenever a input current flows above the certain specified
value then MCB interrupt the phase i.e. break the circuit.
This certain value is define by rating of MCB connected on
a particular ciruit(for light circuit or power circuit).
helps to prevent fire or short circuit.
Is This Answer Correct ? | 7 Yes | 2 No |
Answer / santhi swaroop
MCB means miniature circuit breaker.it compares current
between phase and neutral conductors and difference exist
than interrupt the phase i.e. break the circuit. simply it
is differential coil circuit breaker
Is This Answer Correct ? | 7 Yes | 21 No |
Answer / sudarshan singh
MCB mean is moulded circuit breaker. It is used to triping
the over current against use to spacify mcb rating. MCB is
many type as B-Class, C-Class & D-Class. C-Class type mcb
mostly used in industrial area.
Is This Answer Correct ? | 4 Yes | 23 No |
what is power transformer?
what will happen when ac is applied resistor,inductor,capcitor?
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
what is two wattmeter test
WHAT IS THE DIFFERNCE BETWEEN AIS AND GIS IN SWITCH GEAR?
why field rhoestat is kept in minimum position while armature rheostat at maximun position?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
For 160kw motor what size of cable and material is needed.?
its Kva and Kv are same?
what is difference between co-generation and captive power plant?
Why the transformers are rated in KVA. ? in new view.