A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.

0 Answers   MNC,

---

find the kp ki kd from the transper function G(S)=29.44s+04707/1.5349s2+s

0 Answers  

---

what is the criteria to decide conductor size of a cable ?

0 Answers  

---

Explain about signal isolator

1 Answers   TCS,

---

I need to know steps to Calibration Valve Guard......

0 Answers  

---

---

please explain clearly in PID controller if We increase P only what will be action of the contrlere.

1 Answers   IMECO,

---

how to control motor load with rpm or vfd

1 Answers  

---

What are the Components of Siemens S7 300 Series PLC system ?

1 Answers   Siemens,

---

Dear All can any one told me that VFD Make ABB Model ACS800-01 used for dual Source like 1.DC Source applied at terminal UDC+,UDC- 2. 3 phase 400AC,50Hz

1 Answers  

---

why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.

0 Answers   ONGC,

---

I have a LT of 10000mmwc range. can i use this LT in 1000mmwc range of tank?? if yes than what happened???

3 Answers   Nirma,

---

How to zero trim the level transmitter by using foundation fieldbus communicator.

2 Answers   Emerson,

---