Answer / somasekharan

hmi is located in hazardous area,it shall be flameprrof

In which principles tx ,pressure gauge,Temp gauge,control valve works?

0 Answers   Bajaj, Professional Instruments,

---

when the force applied on load cell the ohms will be varriying .and how its convert ohms to mv generate and have any formulae?

1 Answers   UETCL Uganda Electricity Transmission Company Limited,

---

A pressure transmitter with a range of 0-100 bar.The accuracy of the instrument is 1% of upper range value? The pressure indicating transmitter is showing the system pressure is 50 bar. b. When you include the error, what is the minimum possible pressure in our fuel gas system? i. 49.5 bar ii. 49 bar iii. 1 bar iv. 0.5 bar We want to change the filter cartridge. We must depressure the fuel gas system. c. After we depressure the system in preparation for maintenance, the transmitter displays a pressure of +0.1 bar. At this time, what is the possible range of pressures in our fuel system? i. +0.099 to +0.101 bar ii. 0 to +0.2 bar iii. -0.1 to +0.3 bar iv. -0.9 to +1.1 bar

3 Answers  

---

how to calibrate transmitter

3 Answers   Sabic,

---

In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?

0 Answers  

---

We are using Rosemount 5400 series Radar Level Transmitters in all types of Sump Applications having oily water hdrocarbon petrochemical nature. What we are facing the problem frequently is that always getting reading frezzed at some value. If we do power recycling , sometimes it is working . then making same freezing problem. If anybody faced before such type of problem and also having solution , Please give the answer.

0 Answers   Sabic,

---

While giving Power Supply of 24 VDC to a Transmitter,why Shield Terminal is connected either at Transmitter or at ISB.Why not Shield Terminal connected at both ends.If the Reason is to avoid Noise interference,which type of noice that is interfering.Is the Noice from the 24 VDC supply terminals or from any external source.

1 Answers  

---

Why we are using PLC instand of DCS in ESD System? can u explain any one?

2 Answers  

---

What's the difference between cold loop test and hot loop test?

5 Answers  

---

How to work DCS? how to get the signal from Field Instruemtns to PIB to Console?

2 Answers   Alstom, Invensys,

---

Explain why plc require in analog input 4-20amp & 0-10 volt?

0 Answers  

---

pls send me the 10 years technical question papers of NTPC AND BHEL

15 Answers   Bhel, NTPC, ONGC, UCE,

---