why co incidence factor considered in transformer sizing?
No Answer is Posted For this Question
Be the First to Post Answer
Why in earthing, the earthing plate is put in vertical position? and further what is soft coke that is used in earthing?
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
hwat type of motor is used in thermal gas turbine hydro nuclear power plants and why
why restricted earth fault protection can not operate for phase faults??as there will be a current in secondary of ct,when a phase fault occurs!
whay we transmit power in 3phase no in 4 or 2 or 5......etc?
"What is the difference between voltage and potential differnce?"
what is the equation of converting KW into HP ?
Can we loop AC neutral wire with DC neutral wire?
HOW TO CALCULATE THE WIRE SIZE FOR THE GIVEN LOAD?
If short circuit ratio is high is it bad or good for a machine then tell the reason...
how to calculate AH of a battery?
BRIEFELY EXPLAIN MEGGAR PRINCIPLE
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)