Answer / prabhat patel

pressure is the normal force acting on the surfface of a
close container, while stress is the resistance offered
against the applied load/pressure. both are same by unit
but pressure is in case of liquid and gas while the stress
is in case of solid.

Answer / mech

Pressure is defined as force acting pre unit area...


whereas stress is internal resistance force developed by
material when a tensile or compressive force is applied on
it...

Answer / vigneshwar.r

pressure is the applied force acting per unit area on the
body.


Stress is the induced force acting per unit area on the body

Answer / mechpower09

stress is developed only when the external force is applied.
whereas pressure is induced from external sources only.

Answer / rushi

Stress ia an internal resistance of body i.e. it is Reaction
force,
while pressure is an external quantity i.e. Action.

So we can say in other way as we can apply pressure not
stress on body..

Answer / bharath

pressure is a sub set of stress, we have many kind of
stresses but the stress which is acting normal to the plane
of force applied we cal it as pressure.

Answer / mithilesh rane

stress is a quantity acted on body by ssome force but
pressure is force acted by surrounding on system

Answer / ravikesh

presure is measured in close system where as stress is
bulid on system . presure is acting under the system,
stress acting on the system.

Answer / saurav sahrma

pressure is comes under the system andstress is on the
system for example-a gas exert a pressure in beaker and
stress is

What is the material used ball screw rod

0 Answers  

What is a positive displacement pump?

0 Answers  

When mesuring the flow of liquid what are the two things to measure?

0 Answers   Reliance,

I have 1010 KVA Generator when i run the DG set for 5 to 6 hours the couplling (couplling joint in between engine & alternator) bolts are getting loose what is the reason & what is the remedy over this??????????

7 Answers  

in the design of a rack and pinion with the pinion having a pitch of 4in and a teeth number of 45,how many teeth should a rack of length 196.850in have

0 Answers  

what for orifice using in liquid flow line

9 Answers  

What is a vee used for on the vee block?

0 Answers  

i need bhel written test question paper for the post of mechanical engineer (je)

1 Answers  

How are the bearing numbers given?

5 Answers  

Why diesel engine is known as high torque and petrol engine as high speed engine?

1 Answers  

Dear all, How will we calculate the Diesel engines ( generator) efficiency considering fuel

1 Answers  

What will happen if boiler backfires?

0 Answers   ABC Inc, RRB, Siemens,