relation of cop with ikw/tr?

0 Answers  

---

What is conduction?

0 Answers  

---

during starting of centrifugal pump mechncal seal is required to be vented first

1 Answers   Nirma,

---

Please tell about the water type h.v.a.c with it's cycle and functions of each parts ?show me how talented u r?

0 Answers   Blue Star,

---

plz send me mahagenco previous exam paper on my email-id sameersatelkar@yahoo.co.in

1 Answers   ETA, MahaGenco,

---

2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand

0 Answers  

---

Explain how fast is a jet plane?

0 Answers  

---

What do you understand by eutectic ?

0 Answers  

---

How do we differentiate oxy & acetylene?

1 Answers   TATA,

---

What is Evaporator?

3 Answers  

---

Where oranges are mostly found in india?

1 Answers   DEI,

---

We select 10mm nominal thickness for Elip head of a pressure vesel. The minimum thickness after forming is 8.2mm. (Shell thickness is 8mm. The minimum thickness after forming is satisfied or not with UG-79 (d)(3) in ASME SECTION VIII, Div.1?

0 Answers   PetroVietnam,

---