what is the principle of vibration

Question Posted / prakash h kusuma

3 Answers
7849 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what is the principle of vibration..

Answer / kondedshivu

it works on the principle of electro-magnetic flux

Is This Answer Correct ?

6 Yes

4 No

what is the principle of vibration..

Answer / nileshkumar jambukiya

non contact type vibration sensor is work on eddy current
prenciple, when gab between object and sensor is increse
then more eddy curent drown so this current convet into
voltage in its transducer so maximum volage out put get
and vice versa minimum gap between object and sensor.

Is This Answer Correct ?

2 Yes

1 No

what is the principle of vibration..

Answer / u.nathan

dynamic state of an object

Is This Answer Correct ?

1 Yes

1 No

Post New Answer

More Instrumentation Interview Questions

what should he know if he is an assitent engineer instrumentation in cement industries of experience of 10 - 15 year.

0 Answers

i have 80cm water tank.how can i use DPT as level mesurment.pls give specs for that..? We have air comp.from that moisture comeout to one tank.i want to mesure level of water in that tank and then after operat one sov to dicharge water after high level.

1 Answers

what's the criteria of using over range protector when installing Pressure Gauge

1 Answers

What is the working principal of Mass flow transmitter?

1 Answers

we have a s-5 simense plc having op7 .recently on op7 showing error 1.plc not present 2. DB error frequently. can u have any solution . please send me.

0 Answers

I am going to attend a recruitment drive by Schneider in 2 weeks. They have a technical test in the beginning. I would like to know what are the areas i should concentrate on while preparing for the test. My major is Electronics and Instrumentation.

1 Answers

What are different types of control valves?

0 Answers

Difference between ultra sonic flow meter

0 Answers

I HAVE PRESSURE TRANSMITTER WITH TWO WIRES 24 VOLTS SUPPLY.IF TRANSMITTER WILL GIVE SIGNAL TO THE DCS WHAT HAPPEN TO THE 24 VOLTS POWER SUPPLY IT WILL DROP OR REMAIN TO 24 VOLTS POWER SUPPLY.

3 Answers

On LPG sphere tank we used LIT for level indication.High side port is connected to the bottom of the tank while low side port connected to the top. I would like to know how to fill the glycerin on its low side with two condensing pot installed,one from top and the other one for its drain line.Please I need your expertise...thanks

1 Answers

A motor is taking 15 Amps at no load and 60 Amps at full load. and a valve has to open 10% at full load and 80% at no load. How to draw ladder logic.(PLC).

2 Answers

Waht is surge in compressors and how to control it?

1 Answers DEWA,

For more Instrumentation Interview Questions Click Here