1)we r having one problem .one dry type transformer(6.6KV/433V)is taking high m

1)we r having one problem .one dry type
transformer(6.6KV/433V)is taking high magnetizing current on
delta connected HV side of "U" phase when compared to other
two phases.could any body tell the reason why it is happening?
2)why CT secondary side protection core has got higher
winding resistance when compared to that of metering core of
same CT?

Question Posted / ravi21176

2 Answers
5251 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

1)we r having one problem .one dry type transformer(6.6KV/433V)is taking high magnetizing current o..

Answer / tanvir s.

Answerin ur 2nd query:
As we kno the flow of current is inversely proportional to the the resistance. Hence a lower resistance winding on the metering core of the CT would ensure a sensitive/accurate current(ampere) reading. Following the same principle the protection core has high resistance to limit the flow of over current and step it down to the calibration of the metering side.
Pls feel free to correct me if i am wrong or not clear

Is This Answer Correct ?

2 Yes

1 No

1)we r having one problem .one dry type transformer(6.6KV/433V)is taking high magnetizing current o..

Answer / mohamed

1.Check for no of turns ratio
2.check for phase angle difference
Sec side of CT always handle more current comparing to primary side

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

Why electricity is generated and transmitted at the values of multiples of 11?

3 Answers

DESCRIBEPNEUMATIC SYSTM OF ASH HANDLING PLANT

0 Answers

what is the difference b/w conductor and semicoductor

1 Answers

I am doing apprenticeship training at HT switch yard in NLC. How can i get electrical c license. ??? What r the rules for getting it as an apprentice? ??

0 Answers

To test Transformer we give HT side 440V to see wheather that it is producing 17.6V on LT to verify Voltage ratio is correct or not but when we give the 440V voltage to LT side then what will happen to HT voltage ?

3 Answers Aditya Birla,

why incomer bay is required before transformer bay if there are more than 1 nos. of transformer bay.

0 Answers

What do you mean by linear and bilateral network?

20 Answers Automation, Disa, EGCB, Infosys, OPTCL, TICT,

why the efficiency of the dc machine is high ,when it is operated as a generator?

3 Answers

what happen if position of GNA and MNA is changed in machine?

3 Answers

. Is there a simple method to measure the horsepower of a small motor (1-3 hp) for a non-technical person

2 Answers

What is a roll of a adopter pannel in buscoupler pannel????

2 Answers

OHMS Law is only applicable for ac or dc or both circuiT?.

6 Answers

For more Electrical Engineering Interview Questions Click Here