Answer / sjtbehera

When a force applied to a object it will try to compress
the structure. so structure will bend. so a bending
moments " bend" an object but it is more like a twisting
motion on the long side of the object. This bending moment
is main factor decide reinforcement of structure.

Answer / aditya richie

the points where bending moments are maximum are points of
maximum stress , therfore these points require more
reinforcement with steel to counter the stresses . Whereas
at points where stresses are less , curtailment of steel
can be done .

Answer / nitesh sankpal

Bending moment is nothing but the internal stress developed
in structural element when external forces or moments are
applied on structural element which tend to bend.........to
avoid the bending of member reinforcement is used.........

Answer / prashanth

A Load is applied on a certain area,then on that area thier
will be chance of some bending,to avoid that bending
reinforcement will be provided at the bottom to take
tension & at top compression.
Even though top bar will take compression,concrete will
also take the compression load.

Answer / unknown

BENDING MOMENT IS THE ONE WHICH TRIES TO RESIST THE STRUCTURE AGAINST FAILURE(LIKE SHEAR FAILURE) DUE TO LOAD APPLIED ON THE STRUCTURE,HERE REINFORCEMENT HAVE THE KEY ROLE TO RESIST THE STRUCTURE

How calculate the water for 1m3 concrete

6 Answers   DLF,

How to design staircase.plz tell me formula for the design the staircase.

0 Answers   DMB Construction,

what is the standard gradient or slope for drainage?

1 Answers   IGC, SPL,

What is the size of your cube mould

6 Answers   Inforce,

How to produce the Concrete Grade 30mpa at 12hour? How to prevent for plastic shrinkage crack? How can we produce fire resistant concrete?

0 Answers  

what is superbuilt-up area in flats & how it is calculate?

5 Answers  

what are the changes in concrete pour height as per IS 456, 2009?

0 Answers  

what is the meaning fe in steel?

1 Answers   Manjeera, Oceanus, PAN, URC Construction,

what would be the rqmnt. of cement and sand (1:6)for building brick wall and also 20mm thick plaster on the wall by same ratio?

1 Answers  

how to do cementicious paint for rcc walls of cw pump house

0 Answers   APGenco,

Plz tell how to find out stell bend correction for all angle of bend and in where it is? Plz answer

1 Answers  

Which standard describes the tolerance limit for undulation of RCC wall/ after POP surface?

1 Answers