1.What is the proper definition of power system stability? 2.some times a blue

1.What is the proper definition of power system stability?
2.some times a blue spark is visible in the secondary side
of a distribution transformer at the contact position of
bushings and fuse wire,why?

Question Posted / dey84.atanu

1 Answers
4508 Views
I also Faced
E-Mail Answers

1.What is the proper definition of power system stability? 2.some times a blue spark is visible in ..

Answer / t.swaminathan

1.System stability is generally continuos maintenance of
power with proper voltage levels. Mainly it means the GRID
VOLTAGE CONDITION / REFERRED DOWN TO THE 11 KV LEVEL.

SYSTEM IS SAID TO BE STABLE IF PROPER VOLTAGE IS MAINTAINED
WITH RATED FREQUENCY.

IT GETS AFFECTED WHENEVER THERE IS BREAKDOWNS OF
TRANSMISSION LINES/POWER GENERATION.in which case the load
is to be met by lessor power momentarily,till the
generation picks up referred to the lower/higher frequency
due to the breakdown.

2. This is simply because the connection in the LT side of
the transformer is not proper. ( loosened ).

Is This Answer Correct ?

2 Yes

3 No

Post New Answer

More Electrical Engineering Interview Questions

star delta connection used in reduce the starting current at 3 times . how its reduce the current please explian .

7 Answers HP,

DRAW THE DIFFERENCE BETWEEN GROUND AND NEUTRAL IN BOTH SINGLE PHASE AND THREE PHASE?

2 Answers

what is the differance of acb and mcb and mccb

12 Answers MacAir, MDS,

Whether it is possible to measure energy at the input of rectifier transformer (12 pulse with very high odd harmonics)

0 Answers

what is the best transformer oil breakdown voltage?

0 Answers

why should the primary of transformer be connected in delta in a heat run test?

0 Answers Bhel,

why transformer rating in kva and motor rating in kw

11 Answers

I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?

0 Answers

can i have the methods of speed controls for 3 phase AC MOTORS.

7 Answers

what is the diffrent between ups and inverter

2 Answers ABB,

what is full form of google

5 Answers IBM,

i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?

0 Answers Crown Buildtech,

For more Electrical Engineering Interview Questions Click Here