What is Scott connection?
In which device it is used?
Answers were Sorted based on User's Feedback
Answer / iamdon
Scott connection is a means of converting 3 phase supply
into 2 phase supply.
The angle between two phases is 90 degree.
It is employed with the help of transformers namely
1)Teaser transformer
2)Main transformer
Author:arbelectbit@yahoo.com
Is This Answer Correct ? | 104 Yes | 5 No |
Answer / praful nandnakar
Scott connection is used to interlink 3-phase to 2-phase
or vice versa.It has two transformers i.e. teaser and main.
Is This Answer Correct ? | 46 Yes | 10 No |
Answer / vijay
converting 3-phase to
2-phase transformations or vice versa. generally,2 identical
transformers are purchased as
that they can be interchangeable. This requires an 0.866 tap
on one transformer and a
midwinding tap on the other.
Is This Answer Correct ? | 26 Yes | 1 No |
Answer / neha kedia
scott connection (scott T-transformer) is a type of circuit used to derive two-phase (2-φ) current from a three-phase (3-φ) source or vice-versa. The Scott connection evenly distributes a balanced load between the phases of the source.The Scott-T transformer connection may be also be used in a back to back T to T arrangement for a three-phase to 3 phase connection.
Is This Answer Correct ? | 8 Yes | 5 No |
What is the difference between Ac curent & DC current
Which motor has high Starting Torque and Staring current DC motor, Induction motor or Synchronous motor?
I have 10 amp MCB for my air conditioner of 1.5 ton capacity. When I connect the ac direct it is started running but when connected through stabliser the Mcb Get trip and air conditioner couldn't start.please confirm whether Mcb is required to be upgraded to 20 amp. There is no fault in ac and the stabliser. Please advice the reason of tripping the mcb when connected through the stabliser.
The current though a branch in a linear network is 2A when the input voltage is 10 volts. If the voltage is reduced to 1 volt, and the polarity is reversed, what is the current flowing through the branch ?
how many bulb of 60watt at 300volt is used to maintain 0.25 amp.with valid reason?
comparision between ACB and VCB
The normal highest generated voltage in India is a) 6.6KV b) 132KV c) 11KV
what do u mean by starting torque? how it should be for a good motor? what is the relation between starting torque and power factor? What is the relation between efficiency and starting torque?
how can we use isolator as breaker
what is ground fault current? is there any current flow takes place through ground? is it possible? if it's possible whether it affect human beings on earth near the fault or not?
What is the similarity and what is the difference between relays and PLC?
what is AH of battery