Answer / sjtbehera

all are 1:1:2

Answer / shanmugam

m7.5 = 1:5:10
m10 = 1:4:8
m15 = 1:3:6
m20 = 1:2:4
m25 = 1:1.5:3
m30 = 1:1:2

i think there is a ratio for m35= 1:1:1
and after that only the mix design starts........

what is cross hair cursor?

0 Answers  

---

for basic costing, how can we calculate how much amount of steel and cocrete will go in per sqft? and what are the thumbrules?

1 Answers   Symphony,

---

Are you comfortable with formal design concepts in the home furnishings area?

1 Answers   ENI, L&T, SPML,

---

How much stirrups spacing required for.column reinforcement?

3 Answers   L&T, Ocean Interiors,

---

plz tell.. how can we find weight(in kg) of 1 cum of m20 mix..? how can we find the ratio of cement sand and agregate on site i.e if we given some amount of m20 mix then hw we find the ratio..?

7 Answers  

---

A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.

0 Answers  

---

please, what is the required bar for a column of 6mx6m the dept is 405mmx300mm,its an axially loaded ?

0 Answers  

---

how to calculate the chair reinforcement length in slabs, footing or anywhere??

0 Answers  

---

How do you calculate qty for form work like props shuttering sheet and acro span for residential block ? for Example: 10 sq mt what is the material and qty require to do form work.

2 Answers   L&T,

---

Consumption of Binding wire for fixing of cover block in vertical surface

0 Answers  

---

what is the composition of good brick ?

0 Answers   Exim Knits,

---

Compressive strength of concrete

5 Answers   B L Kashyap, Era Infra Engineering,

---