Answer / iamdon

TWO REACTION THEORY is employed for the analysis of salient
pole rotor synchronous machines.

Blondel is credited for the theory.

Yes,Same theory can be used for the analysis for
cylindrical rotor synchronous machines also.Actually
salient pole rotor is a general case where as cylindrical pole
rotor is special case.

In case of salient pole, the air gap is not same with respect
of time.So rotating field faces different reluctances.The gap
is minimum in polar region and is maximum in interpolar region.
By Two reaction theory we break the rotating field along two
axes namely
1)Direct axis and
2)Quadrature axis.
The advantage of the breaking is that the air gap became fixed
(so the reluctance) along both axis seperately with respect of
time.So analysis become quite simpler.

Author:arbelectbit@yahoo.com

which gas is filled in CFL

7 Answers   Lumax,

---

Why the dc voltage drop during starting of emergency lube oil pump? The Voltage drop from 135kv to 125 kv for one min. before re-establish to 135kv?

0 Answers  

---

what is the chemical name for oil that used in the transformer

2 Answers   NCC,

---

What is Ohms law?

28 Answers   College School Exams Tests, KPTCL, L&T,

---

What is the suitable rating of MCB used for 1.5 Ton A.C & why?

4 Answers  

---

---

how is the testing of an REF relay? what are the test REF circuit having?

0 Answers   Siemens,

---

Dear sir, How to calculate 3.5 core pvc aluminium armoured cable meter wise carrying amps rating.Please give the solution with a good example.

0 Answers   Modi Builders,

---

the resistance of wire having length X M is R OHEM if i streched the wire to dubble length what will be the resitance

3 Answers  

---

as per BIS supply voltage in India is ......

9 Answers  

---

why protection meter is always connect to star

1 Answers  

---

One of our gas turbine generator unit "1st stage rotor ground fault" alarm was occured several times. we tried to measure some voltage vulue ground fault protection relay (UNS3020a made by ABB and we measured the value of: Ground: 0.9VDC 5V: 5.8VDC 24V: 23VDC u+: 300 – 350mVAC Rf1: 17.5mVAC Rf2: 17.6mVAC The unit still running and the alarm was reset. As of 6pm yesterday and unitl now no alarm happened again. I our protection relay was defective?

1 Answers  

---

Why power factor does not occur in DG set ?

6 Answers  

---