What size cable (based on voltage drop) is required to supply a 40 A three pha

What size cable (based on voltage drop) is required to
supply a 40 A three phase boiler if the wiring system is
75V single insulated cables installed in non-metallic rigid
conduit 56m from the main switchboard? Voltage drop in the
consumer's mains is 8V.

Question Posted / michael

0 Answers
1921 Views
I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

How the electric train gets the supply of electricity? What is the return path of the current?

7 Answers NTPC,

while calculating the power absorbed by a resistor connected to the output of a half wave rectifier circuit should we use rms or average current? explain with reason.

1 Answers Vedanta,

How does a VOLTAGE OPERATED DIFFERENTIAL RELAY work??

2 Answers

why a vaccum is created in condenser

13 Answers Honda,

What will be the total current for 300kva UPS if it runs on 40 to 45 percent load. Is there any formula for to calculate the exact load.

4 Answers Sodexo,

what s the differenc between electrical &electronis , how to define them

9 Answers

Difference between a pilot wire and a normal conductor?

0 Answers United Arab Aluminum Company,

The insulation resistance of a cable can be measured by

3 Answers

What is the effect on Power factor and capacitor when your company load is more than 70 % of welding transformer

0 Answers

What is the accepted limit to increase the choosen transformer capacity over the load and why ?

1 Answers

What does negative slip of an induction motor signify?

10 Answers Tata Elxsi,

at high temperature conductivity increases for conductor what will happen for long transmission when temperature is high?

1 Answers

For more Electrical Engineering Interview Questions Click Here