How to calculate the actual 3phase power, if the load
current of each phase is not balanced

Answers were Sorted based on User's Feedback



How to calculate the actual 3phase power, if the load current of each phase is not balanced..

Answer / shariff

It is recommended to use two watt mater method, then W1+W2 will give total power in all the 3 phase, this method can be used for this un-balanced load conditions.

Is This Answer Correct ?    5 Yes 1 No

How to calculate the actual 3phase power, if the load current of each phase is not balanced..

Answer / subbarao

Measure power in all the 3 phases separately and add them.

Is This Answer Correct ?    1 Yes 2 No

Post New Answer

More Electrical Engineering Interview Questions

why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?

0 Answers   OGDCL,


You are of electrical field and you are going for software? Why

0 Answers  


What is best method of Calculating Short Circuit current in power system network.

1 Answers  


WHY FLEXI LINKS ARE USED INBETWEEN GENERATOR TERMINAL OUTPUT & BUS DUCT CONDUCTOR.

3 Answers  


A Generator is in running condition and Rotor earth fault alarm is coming.How to check on line(i.e in running condition) whether there is actual earth fault in rotor or not.

0 Answers  






what is the principle of operation of synchronous motor and generator? explain in detail.

2 Answers   Maruti Suzuki,


I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?

0 Answers  


An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%

0 Answers  


why capacitor bank always connected in delta,why not in star to a system?

15 Answers   NHPC, NTPC,


In case of a synchronous generator carbon brushes, some brushes expire before the others. Why is so? When all the brushes are installed at the same time, why don't thee expire at the same time?

1 Answers  


My meter ratio is -/5 and ct ratio is 100/5 now what will be the multiplying factor and how ?

1 Answers  


How many types of Differential protection are there? and what the special arrangement are made at the time of charging of a transformer on the Differential protection?

1 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)