Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculate the actual 3phase power, if the load
current of each phase is not balanced
- 2 Answers
- 5098 Views
- I also Faced
- E-Mail Answers
Answer Posted / shariff
It is recommended to use two watt mater method, then W1+W2 will give total power in all the 3 phase, this method can be used for this un-balanced load conditions.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
what are the condition that makes hooter blow?
What is the rating factor for copper cable ( Specific value according to the type of laying ) & the voltage drop?
how can i get the formula to find out the cable size if i know the load of main fuse protection.
How is the gain affected by the introduction of feedback in a control system.
how does high earth to neutral voltage affects electronic circuit?
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
How to test the vector group of a Yd11 transformer? what are the relations to be checked between various vectors to confirm this vector group?
In case of generator when we consume more power produces by it why load on generator increase and starts sound more. and how it is adjusted..
What is the principle of HIGH SPEED DIRECT DRIVE MOTOR ?
I want to know the 'Test voltage' for Tandelta testing of 3.3 / 6.6 / 11 KV Motors. Please explain
what will happens if one phase is missing for 33/11kv power transfomer and why?
what is the function of impulse relay
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
How to calculate cable size in HT AND LT
If mutual flux is 1.2wb & power factor is 0.8 lag , then what is the Useful flux of a transformer?
