What is required of exietation to the alternater.

Answers were Sorted based on User's Feedback



What is required of exietation to the alternater...

Answer / aman arora

Because to
induce EMF in
alternator some
potential
required and it
sets up megnetic
field. And when
the rotor rotats
in megnetic
filed then that
minor potential
becomes its
rated output
votage

Is This Answer Correct ?    2 Yes 0 No

What is required of exietation to the alternater...

Answer / yaseen

A SMALL GENERATOR IS REQUIRED TO EXITE THE ALTERNATOR .OR
YOU CAN BATTERY OF DC SOURCE TO EXITE THE ALTERNATOR

Is This Answer Correct ?    1 Yes 0 No

What is required of exietation to the alternater...

Answer / bikkinas

a small dc generator used to gave the excitation

Is This Answer Correct ?    0 Yes 0 No

What is required of exietation to the alternater...

Answer / bahadure.kapil

alternater is power generating mashine.to generate power &
to field exietation of alternater.so required of exietation
to the alternater.

Is This Answer Correct ?    2 Yes 3 No

Post New Answer

More Electrical Engineering Interview Questions

What is the range of the stator resistance of 3 phase induction motor?

0 Answers  


What it the purpose of parallel phasing transfomers??

0 Answers   Asia MotorWorks AMW,


Explain why the Voltage drop will happen in 3 Phase line?

2 Answers  


What are the different lines and what are the different types of losses occur on them?

2 Answers  


what is two point starter?

0 Answers   SGF,






what's transient & sub- transient reactance means?

2 Answers  


The current though a branch in a linear network is 2A when the input voltage is 10 volts. If the voltage is reduced to 1 volt, and the polarity is reversed, what is the current flowing through the branch ?

2 Answers  


What is advantages of VSCF wind electrical system?

0 Answers  


there is a power transformer 66/11kV in delta-delta connection has 5 feeder coming out from the secondary side. One of the feeder in it normally loaded (loaded than other feeder)and this feeder usually trips with double OCR causing the bank transformer to trip. Now if the load of this feeder is put on other transformer then that no problems occurs on that transformer or the load. However normally all the test(IR, PI, short ckt, open ckt,grounding test and other ) has been conducted for this but evertything transformer..... I am not geting what is the actual problem...

2 Answers  


what is use of reactive power in ac ckt.

2 Answers  


what is the saturation point of crgo lamination.

0 Answers  


what is the use of switch disconnector fuse

1 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4452)
  • Electrical Engineering Interview Questions Electrical Engineering (16636)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)