in 132 kv transformer , in which range of transformer oil
bdv required ? if it has around 50-55 , then how it was
insulated the winding ?
Answers were Sorted based on User's Feedback
Answer / raj
It should be more than 50kv and this value we got from
voltage applied inbetween 2.5mm gap with bare conductor.In
transformer no bare conductor (conductor with insulation)
and no so much less gap.
| Is This Answer Correct ? | 6 Yes | 0 No |
what is ht breaker
why skin effect is decreases with decrease with frequency? why skin effect occur
WHY MOSTLY Rph IS USED FOR CONTROL CIRCUITS AUX. SUPPLY ?
How to run 1ph motor(230 VOLTS its full load amps is 4.5 ampa))with 480 volts main(we didn hav neutral)Thn we go for step down transformer.Our load 10 amps,so we conisder this amps in primary are secondary side
how to identyfy cable sizes?
HI FRIENDS,MYSELF & MY GROUP OF FINAL YEAR ELECT ENGG. ARE MAKING A 50/3HZ,5HP,1000RPM,440V SALIENT POLE SYNCHRONOUS GENERATOR.COULD ANYONE OF U TELL ME WHAT COULD BE THE ADV. & DISADVANTAGES OF MAKING SUCH A LOW FREQN.GENERATOR/
why dimmerstate always connected in star connection? what will happen if it connected in delta?
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
why in crona effect it give violet colour.
why DC motor body is plain cover but AC motor is different like finse?
Which is the largest hydropower station in the world?
What is difference between Earthing, Ground and Neutral?
1 Answers ABB, ABC, Indo Asian,
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)