if we increase the frequency given to a transformer then wat will happen to the

if we increase the frequency given to a transformer then wat
will happen to the transformer size, whether it will increase?

Question Posted / mail2kowsalya

4 Answers
9018 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

if we increase the frequency given to a transformer then wat will happen to the transformer size, w..

Answer / amir rashid chishti

If we increase the frequency then transformer size will
reduce so it will not increase. In electronics circuits we
often see very small transformers due to high frequency
whereas in power systems we have large size transformers
due to low frequency.

Hope answered the question!

Is This Answer Correct ?

13 Yes

2 No

if we increase the frequency given to a transformer then wat will happen to the transformer size, w..

Answer / k.prakashchandra

It will reduce as less flux is required to build the same back emf which is equal to 4.44 x flux x frequency x turns

Is This Answer Correct ?

0 Yes

0 No

if we increase the frequency given to a transformer then wat will happen to the transformer size, w..

Answer / javad

No.there is an expansion and contraction in each cycle.cld
magnetostriction,hence producing humming sound. if we
increas the frequency the rate of exp n con increase.

Is This Answer Correct ?

2 Yes

5 No

if we increase the frequency given to a transformer then wat will happen to the transformer size, w..

Answer / raj

yes it will increase

Is This Answer Correct ?

2 Yes

10 No

Post New Answer

More Electrical Engineering Interview Questions

There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2

0 Answers

What happen if we give resistance to the armatuure of a dc motor?a

1 Answers

how the transformer stables out zone faults? Because we use non directional O/C relays .Is there any special considerations are taking into account to overtake this?

1 Answers

In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes

0 Answers

Leakage current,un balance current which relay using for high voltage transmission?

0 Answers Banking,

Explain the advantages of the wheatstone bridge method of measuring resistance?

7 Answers

What is cathode ray oscilloscope (cro)?

0 Answers

why surge suppressor in vaccum circuit breaker and it is only in motor feeder why not in tranformer feeder?no surge suppresor in ocb in motor feeder?

1 Answers IOCL,

How many no of flip-flops are required to get 16 bit counter

10 Answers HAL,

how to reduce shorting current in a slipring induction motor