Answer / dharamveer yadav 09826656679

basically direction of motor depend on phase of supply if
we inter change any two phasethen rotation of motor will be
change

Answer / lohith

Interchanging any two phases leads to change the direction
of rotation.

I know during Surge Impedance Loading maximum power is transferred through a transmission line and also Sending end voltage becomes equal to Receiving end voltage i.e Vs=Vr so my question is if both end voltages are equal then how current travels in such line hence how power is transmitted because flow of current needs Potential difference??

3 Answers   NTPC,

---

How we connect capacitors in Fixed Series compensation of AC transmission lines. Whether in parallel or in series?

3 Answers  

---

What will be the current drawn by HT motor, if low voltage is applied.. any formula to calculate the LT amps of HT motor.?

0 Answers  

---

what is the diffrence between single phase and three phase

6 Answers  

---

working

1 Answers  

---

Why does the rotor rotate?

1 Answers   Machino Polymers, OPTCL,

---

what is the d/f b/w dol & star delta starter.

2 Answers  

---

IF WE SELECT THE 60H FREQUENCY IN INDIA WHAT WILL THE GOOD AND BAD EFFECT ?

3 Answers  

---

In a 11kv/433v transformer,at the LT side ie 433 V side why do we need to put 3.5 core Cable upto Panel.The full load rated Amps is 666 at LV side.What value of current will flow through the Nuetral Conductor.Why can't we use 4Core Cable instea of that?

2 Answers  

---

What are the solutions for avioding sulfide formation at bimetalic (Copper &Aluminium)overhead joints?

2 Answers   HAL,

---

HOW TO SET THE EARTH FAULT SETTINGS IN ACB????????????

0 Answers   General Electric,

---

when the diameter of the core and cable is doubled, the value of capacitance ?

2 Answers  

---