Whr should a joint be located in a beam if the provision of
a joint is unavoidable??
Answers were Sorted based on User's Feedback
Answer / sagar
near the minimum shear force zone is the most suitable section
for the joints.
Is This Answer Correct ? | 4 Yes | 1 No |
Wat is the optimum value of tensile strength of concrete after 28 days?
150mm bricks size how many use 4.14 m3
can anybody provide me the HPCL apptitude papers?am having the test on march 2008 so plz
For Wet Mix Mecadam design what is Optimum moisture content
whaat is the difference between opc and ppc
If we are providing concrete joint in every 10m with water stopper in water tank wall then is it necessary to cut the steel at joint section?
0 Answers Talib and Shamsi Constructions,
Explain what is zoning permit?
what is civil engineering?
2 Answers CPWD, drda, Jal Nigam, NHPC, Uttar Pradesh Jal Nigam,
material calculations for I st coatplastering 16mm CM (1:5),second coat CM(1;3)4mm thick,pcc(1:4:8),RCC M20,lime stone masonry CM(1:6)
what is the ratio of young's modulus of elasticity for a mild steel specimen in tension and compression?
what are the advantages and disadvantages of using bentonite slurry in bored cast in situ piles, both in terms of design and execution point of view.
What is rate of concrete surface rendering work per sqm