Interested to Buy Any Domain ? << Click Here >> for more details...
Whr should a joint be located in a beam if the provision of
a joint is unavoidable??
- 2 Answers
- 6418 Views
- BMTC, I also Faced
- E-Mail Answers
Post New Answer View All Answers
Sir, Iam Applied in rrb for the posts of Junior Engineer.I want to know about the or question previews to study well.Pl send it to shukla_varun1985@yahoo.com.
how much percent are used 20mm,10mm?
How to calculate quanty of steel in four leg stirrups?
In a beam,stirrups are placed closely at ends than at centre due to shear.similarly where would ties be closer to each other-at center or at ends in a column and slab.
What are the govt approvals required for starting of power project. means from initial site grading and excavation work.exm. blasting in hard rock, deep excavation, cut off trees from site.
3. A vane 12.5 cm long, 8.8 cm dia was pressed into a soft clay at the bottom of borehole. Torque was applied and the value at failure was 55 N-m. find the shear strength of the clay on a horizontal plane.
What is the mix propotion of M10,M15,M20,M25,M30,M40,M50.M60 cement content,aggrigate,sand and water ratio.
Technical Question of Civil Engineering
How do you prepare Material Recovery Statement for deduction from contractors bills?
How to Calculate Materials Required for PCC 1:4:8 for 1Cum & Brickwork 1:4 for 1Cum & Plastering 1:4 (15mm Thick) for 100Sqm & RCC 1:4:8 & 2mt ( L1=1mt & L2=1mt ) length of 12mm Steel bended in 90degrees what is the formula to calculate Weight & Actual Length ?
What is aggregate?
How much qty of stone ; sand; cement in R/R stone masonry of 136 CUM
WHAT IS YOUR CURRENT SALARY
how much cement is consumed by a stone masonry wall 17.7m long,0.55m wide and 1m high
what might be the problem faced in the near future if the M-sand is used in the place of river sand during wall plastering? (As per IS)
