plz send me the placement interview question and answers of whizchip(technical and apttitude)..i have an interview in next.
4986I don't understand why when we connect high voltage source in DC to electronic motor , we must add capacitor and resistor in parallel ? (I know that we use capacitor because we want to absorb the current that in the first second electronic motor in opposed with current course produce. ) what are the feature of Resistor and in such situation ?
1871It is used or not HT cable single core 630 sqmm in LT 3 phase capacitor bank which is used in PCC(power control center).
1 3505diesel generator not getting start so whats problems will happen to DG and how we can start DG
1 4680Post New Electrical Engineering Questions
What Maximam Gap Taibaar & Bush
why the check zone and main zone are used for Busbar Protn. scheem?
How many energy meters can be connected on a 15VA Voltage transformer. please send a calculation sheet.
1)how to reduce the value of tan delta of trasformer and CB,bushing,CT&PT,CVT ? 2)how to reduce the resistance of CB contact and its operating time? 3)plz.....send me the project report on conditioning and monitoring of substation equipment on my email id (gusaiyogendra03@gmail.com)
HOW DOES THE ELECTRONIC ENERGY METER WORKS?
Explain the construction of the conservator, operation and purpose, and draw the diagram of the conservator.
what is the current density of copper & alluminium.
If the earth is a good conductor of electricity, why don't people get shocked every time they walking on earth?
A ray hit a smooth regular surface at an angle of 20 from the normal. Calculate : 1. The angle btw the incident and reflection ray. 2. The angle of deviation.
There is any especial requirement for motor to drive through with VFD?
How to Calculate KA Rating of Main LT Panel
On 400 amp factory load how kvarh capacitors provide
what is the acceptable limit value for Desolve Gas Analysis/
Can Anyone suggest the Standards (IEC or IS) for selecting copper current density?
Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example?