why selected genration, transmission or any at 11kv, 132, 220, 220 or 440 voltage which is propotional to 11. why does not any for ex. 12 kv 13kv or any
2 6408Post New Electrical Engineering Questions
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases slip A does not alter B decreases C increases D none of above
Why Neutral Isolation is required?
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
Plz tell me how we can find that particular company has vacancy or not
What is systematic error?
which types of relay used in acb and vcb?
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
Electronic circuit
State ohm’s law?
What are conduct on the testing in cf in ur site?
How to calculate the phase to phase clearness of HT /// LT bus bar?????
What is the important precuations need tocarried out while working with Electrolite in Battery PM?
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
How to calculate the value of earth capacitance in a transmission line.
What is difference between start imitation and start interlock for 3 phase motor protection ?