Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) What are the different types of testing? What is SDLC? Manual of automated?How to choose among these two?
2268Does magnetomonopoles exists? one maxwell equation strongly suggests no, but how about their existance in plasma?
2021Why do we use compressor in pumps for pumping water through borewells? Submersible pump is enough then why do we go for this method?
4 12323why our indian system choose the 230 volt for single phase&415 for 3-phase voltage,in forign side 110 volt is used what is the difference
4 20594can any one please tell me the optionals for group-1 mains.actually i am preparing for civils.i took one optional.
2287
when air is supplied from larger diameter pipe with some pressure if change diameter to small pipe the pressure increases or not? also what is increased pressureor velocity?
can you give me the solution of iiie
why boiler is closed system ?
what is the heat insulation material is adaptable for a flue gas duct that carries waste heat from brick kiln to brick drier and what temperature is required to maintain at the tunnel to dry adobe bricks adequately
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
Test procedure of fly ash bricks as per code ?
Define closed loop control system.
salam&hi, i need to know about how can i calculate an enough current for the new building before i submit it to the suppliers
what is the difference b/w pvc cu conductor and cu breaded wire..?
Can we weld hot rolled steel ASTM A615 ? Please Give the detail answer please thanks alot
why single CT used in DOL starter power circuit?
hi, i have completed my b.e. marine could u pls suggest me some job site for marine engineering?
in single linked list , each node contains data and address of next node. if middle of list the node is damaged/crashed then how to find where the link is failed and how to get the all the data which is stored after the crashed node?
How to find ampere on ht side for selection of cable size ???
what is the need to express current and voltage in rms value? rms value is also called as effective value,what is effective value?