I want previous rrb enteranse exam papers in junior engineer(Signal/Tele/c&w). please send that papers to my id dkg_unnao@yahoo.com

3401

friends....i have been searching the model paper for HPCL officer trainee for chemical eng....tat apptitude section...if u people got any information regarding tat...please send me to my mail...my id is: maruthu.flower@gmail.com...pls send me wtever information u knew....thank u....

2436

Hi Friends pls give information regarding BARC written test. am attending written exam on 1st September 2009.mail me on sanjaykm1982@indiatimes.com/sanjaykumar.b.mathur@relianceada .com

2074

I am a fresher and i have done testing course from orbit institute hyd.can any1 say me whether it is necessary to do project in testing.if it is that which is best institute in hyd.can you please inform me if there is any job 4 freshers.thanxs

1995

sir i want previous entrance exam papers for written test

2232

sir please send me previous year questions of jspl of electrical section through which i could prepare myself fpr the test.

1984

send me test pattern of nsn?

2161

hi i am electronics & telecomm engg & appling 4 the AAI jr executive (electronics/ATC) written test. pls forward me the syllabus & old question papers.I will be very much thankful to you. shahrukhkhalid911@gmail.com and shahrukh_khalid911@yahoo.co.in

1978

Which type of question u have asked to the fresher

1397

Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....

2154

i am preparing for motor vehicle assistant inespector please send me old questions papers.

1997

A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.

2244

I NEED RRB SYLABUS FOR JE ELECTRICAL ,PLEASE SEND TO MY E- MAIL ID joo28_eee@yahoo.co.in

2921

manhole chamber having height of 2300 mm and thickness of brickwork is 230 mm and dia of opening covering is 560 mm and bottom length vertical is 1500 mm (1:4) brick masonry and plaster 12 mm on both sides..how to estimate the no bricks used with mortar cement bags and sand for total chamber including plaster.

1827

this site is owned by an nonsense

2402