Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) In dcs contol valve parameters showing like this Gain=1 or 2 , ti=7 sec, td=20sec. But temp,pressure,level control valves we are using in which type parameter side using ti,td clearly tell me
1 4451In field side transmitter voltage droping here no loose connection then what will happen?
Edac,
2 4831How can we identify a poisoned food if we are not able to sense it?? . .,(naturally by colour ,smell etc. . .)
1 2962
What is the chemical composition of ceramics?
Tell me the reason of connecting domestic t/f primary in star or delta,and also secondary side.
What is the Temperature to be set in Thermostat provided in Marshalling box of the Transformer / Motor.
draw the restricted earth fault protection circuit install on power transformer and identify its parameters and draw C/C curve of it
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
What is the differenc between total moisture and inherent moisture in coal ?
WHAT ARE EARTH MOVING M/CS? WHAT IS BATCHING PLANT? WHAT IS HYDRAULIC JUMP? WHAT IS TIPPER (EARTH MOVING M/C)?
What medical aid is NOT allowed to carry with you on air-craft?
How are the pneumatic system and the hydraulic system similar?
which network topology offers the greatest level of tolerance?
what is vtg limit of earth and neutral at transformer side?
difine electrical ballast in HPSVL
In what ways do you stay updated on the latest developments and trends in aeronautical engineering to continually enhance your skills and knowledge?
Explain important rules that must be kept in mind while designing castings?
What is a low-pass filter?