What effect of supplying stationary generator (800kVA) with 415V AC from 1500kVA transformer?
2 4514while running ,synchronous generator is being turned off.what will happen to the current flow??
1 2590Can we use thermocouple in generator of power station replace RTD(pt 100)? if we don't have any place for use RTD.
2 5452One of our gas turbine generator unit "1st stage rotor ground fault" alarm was occured several times. we tried to measure some voltage vulue ground fault protection relay (UNS3020a made by ABB and we measured the value of: Ground: 0.9VDC 5V: 5.8VDC 24V: 23VDC u+: 300 – 350mVAC Rf1: 17.5mVAC Rf2: 17.6mVAC The unit still running and the alarm was reset. As of 6pm yesterday and unitl now no alarm happened again. I our protection relay was defective?
1 4378
What is a central pattern generator?
What is a central pattern generator (CPG)?
what is the effect of low frequency(say 48Hz) on TUrbo- Generator set when running for a prolonged period?
what is the function generator?
Hi could some one explan what is the use of the function Defination generator, And how to use the function defination generator.. Explan with the example..
How to run an integrated test scenario using Multiple Actions? How to use the QTP Step Generator?
How can you use an Oracle sequences in Informatica ? You have an Informatica sequence generator transformation also. which one is better to use?
boiler is running in rankine cycle and deisel generator is....?
I want to prepare a frequency generator. the specifications i.e. output requirements are 12V, 1-10A & frequency upto 1K to 5K. Please, inform me with proper circuit dig. & the component values.
Disavantages of document generator? How to take a print out of the steps in the Parameterized scripts?
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
what is the criterion for selecting vector group of Transformers ? i mean how to decide vector group of Generator transformer, substation trasformer and transformer at consumer end
Why efficiency of generator is higher than motor at a particular load?
Can you tell me more about pu systems (per unit systems )calculation in large power systems? how to get the base for voltage and power in generator, transformator and transmission lines?
What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?